HomeTrouble CodesB0114

B0114 — Camera Washer Actuator L

Generic OBD-II · all makesBody

This code indicates that the vehicle has detected an electrical fault in the circuit for the left camera washer actuator, which moves or pumps fluid to clean the camera lens. The issue may be an open circuit, a short to ground or power, or a performance problem that prevents normal actuator operation.

Symptoms

What causes it — most likely first

1. Failed left camera washer actuator

The actuator motor or pump can fail internally due to wear, moisture intrusion, or mechanical seizure, causing an open circuit or excessive current draw that triggers the fault.

2. Wiring or connector fault in actuator circuit

The harness or connector leading to the left actuator may develop corrosion, chafing, or pin damage, especially in areas exposed to water and road debris.

3. Open or high-resistance ground path

A loose, corroded, or broken ground connection for the washer circuit can prevent proper current return and cause the system to set a circuit fault.

4. Control module output driver failure

The body or camera control module responsible for operating the actuator may have a rare internal driver failure, though this is much less common than actuator or wiring faults.

How it's diagnosed

  1. Confirm the code and check for related body codes using a scan tool.
  2. Visually inspect the left camera washer actuator, its connector, and nearby wiring for moisture intrusion, corrosion, or physical damage.
  3. Measure the actuator's resistance or current draw and compare the reading to manufacturer specifications.
  4. Test for proper battery voltage and ground at the actuator connector while commanding the system on.
  5. Check continuity and insulation of the wiring between the actuator and the controlling module.
  6. If the actuator and wiring test normal, verify the control module's output signal to rule out a rare module fault.

Code facts & related codes

SystemBody
StandardizationSAE generic — identical on every make

Vehicles this code applies to

The definition is universal; the diagnostics are engine-specific. Open your vehicle for the codes documented for it:

2017 BMW M240i2017 BMW M240i xDrive

Frequently asked

Can I keep driving with the B0114 code?

Yes. This fault affects only the left camera washer function and does not impact engine performance or basic vehicle safety, though camera visibility may suffer in foul weather if the lens becomes dirty.

Why was I told to replace the engine computer for this code?

That is usually incorrect advice. B0114 is a body-system circuit fault for a camera washer actuator and is not controlled by the engine computer. The root cause is almost always a failed actuator, wiring issue, or body control module problem, not the PCM.

Does this mean the camera itself is broken?

Not necessarily. The code refers specifically to the washer actuator circuit that cleans the lens. The camera and its image sensor are typically separate components and may function normally even when the washer system has failed.

Will a clogged washer nozzle cause this electrical code?

A clogged nozzle usually causes poor spray patterns rather than an electrical fault code. However, severe blockage can sometimes strain the actuator pump and affect current draw. Still, the code most commonly indicates an electrical or actuator failure rather than a simple blockage.