Factory specifications, fluid capacities, torque values, EPA fuel economy and the federal safety record for the 1980 Cutlass Salon.
The 1980 Oldsmobile Cutlass Salon is presented as a model that attracted just three owner complaints, with tires being the leading issue, and was subject to five recalls. This low complaint count positions the 1980 Salon favorably within the broader Cutlass reliability record, suggesting fewer widespread problems than many of its contemporaries. For researchers, the data imply that the year’s most notable reliability concerns were limited to tire‑related matters and a modest number of recall actions.
Engine, drivetrain, dimensions and economy.
| Overall length | 196.9 in |
| Overall width | 72 in |
| Overall height | 55.1 in |
| Wheelbase | 108.7 in |
Owner-reported issues, recalls, investigations and service bulletins on record with NHTSA — an unfiltered look at what owners actually experience.
Owner complaints about the 1980 Oldsmobile Cutlass Salon dominate in one area — the tires, 1 of 3 reports (33%), well ahead of the next concern. None of this vehicle's 5 recall campaigns target the tires, so those reports read as owner-reported wear-and-tear rather than an acknowledged defect. 1 of the reports describe a crash and 0 a fire — a small share of the total, but worth weighing against the tires pattern above. These are tallies of what owners actually reported to the federal government, not an editorial score — and higher-selling models naturally rack up more reports.
All 3 complaints on record, top 3 components.
Source: NHTSA Office of Defects Investigation complaint database.
Showing 2 of 5 campaigns on record for this vehicle.
CERTAIN HONEYWELL FRAM RACING BRAND HP4 AND HP8 OIL FILTERS THAT WERE MANUFACTURED FROM MAY 25, 2006, THROUGH SEPTEMBER 14, 2007, AND SOLD FOR USE AS REPLACEMENT EQUIPMENT FOR VEHICLES LIST ABOVE. THE AFFECTED FILTERS… Remedy: HONEYWELL WILL REPLACE THE AFFECTED OIL FILTERS FREE OF CHARGE. THE RECALL BEGAN DURING NOVEMBER 2007. OWNERS CAN CONTACT FRAM CUSTOMER SERVICE TOLL-FREE AT 1-800-890-2075.
REAR AXLE ASSEMBLY MAY HAVE AXLES THAT WERE IMPROPERLY MANUFACTURED. THIS CONDITION MAY RESULT IN SEPARATION OF THE AXLE SHAFT AND WHEEL ASSEMBLY FROM THE VEHICLE. Remedy: THE DEALER WILL INSPECT THE REAR AXLE TO DETERMINE WHETHER IT WAS MANUFACTURED AT THE BUFFALO PLANT. IF SO, THEY WILL MAKE AXLE MEASUREMENTS AND IF NECESSARY REPLACE OR MODIFY…
The most common OBD-II codes for this vehicle's emissions system. These are standardized SAE J2012 definitions, not vehicle-specific fault reports.
Decode factory build data for a specific vehicle by VIN.
Cross-vehicle references for the kinds of data on this page.
NHTSA lists 5 recall campaign(s) for this model year. Check your specific vehicle by VIN.