Factory specifications, fluid capacities, torque values, EPA fuel economy and the federal safety record for the 2017 Qashqai.
Capacities, torques and tune-up values from the factory service manual.
Torque the oil drain plug to 25.0 ft-lbs. The firing order is 1-3-4-2. Note the cylinder-head bolts finish on a torque angle (torque-to-yield) — they stretch permanently and should be replaced, not reused, during any head service.
| Crankshaft Position (CKP) Sensor Bolt(s) | 7.4 ft-lbs |
| Camshaft Position (CMP) Sensor Bolt(s) | 7.4 ft-lbs |
| Engine Coolant Temperature (ECT) Sensor Bolt(s) | 18.0 ft-lbs |
| Oxygen (O2S) Sensor Bolt(s) | 37.0 ft-lbs |
| Engine Oil Pan Drain Plug | 25.0 ft-lbs |
| Cylinder Firing Order | 1-3-4-2 |
| Spark Plug Manufacturer | Nissan |
| Spark Plug Gap | 0.043 in |
| Spark Plug Torque | 14.0 ft-lbs |
| RPM | @IDLE rpm |
| 1 | 37.0 ft. lbs., Step 2: 45 | 37 ft. lbs |
| 1 | 22.0 ft. lbs. | 22 ft. lbs |
| 2 | + 60 | |
Prep Do not reuse old bolts. Use new bolts coated with clean engine oil. Tighten all bolts to finger tight then continue on with the following procedure.
| 1 | 30.0 ft. lbs. | 30 ft. lbs |
| 2 | 100 degrees | 100 degrees |
| 3 | Loosen all bolts completely in reverse order | |
| 4 | 30 ft. lbs. | 30 ft. lbs |
| 5 | 100 degrees | 100 degrees |
| 6 | 100 degrees | 100 degrees |
| 1 | 2.0 ft. lbs., Step 2: 6.0 | 2 ft. lbs |
The most common OBD-II codes for this vehicle's emissions system. These are standardized SAE J2012 definitions, not vehicle-specific fault reports.
Decode factory build data for a specific vehicle by VIN.
Cross-vehicle references for the kinds of data on this page.