Lincoln›Mark VIII›1996›Overview/lincoln/mark-viii/1996/base/

1996 Lincoln Mark VIII

Factory specifications, fluid capacities, torque values, EPA fuel economy and the federal safety record for the 1996 Mark VIII.

Transmission Automatic 4-spd

The 1996 Lincoln Mark VIII is equipped with a 6.0‑qt oil capacity and 5W‑20 API viscosity, mated to an Automatic 4‑spd transmission, and it achieves EPA‑rated 16/24/19 mpg. Over the 1995‑2000 complaint window the model recorded 111 total owner complaints, with exterior lighting as the most frequent issue and only two recalls, a sharp drop from 157 complaints in 1995 to just one by 2000. Consequently, the 1996 model year sits near the low‑end of that complaint spectrum, reflecting a notable improvement in reliability.

Model year1998 1997 1996 1995 1994 1993

Quick specs

Fluid capacities, tune-up values and fuel economy at a glance.

Engine oil capacity6.0 qtOEM · verified

Engine oil type5W-20 APIOEM · verified

Lug nut torque85-105 ft-lbsOEM · verified

EPA fuel economy16/24/19 mpgEPA · verified

Fitment & sizes

Replacement part sizes and factory part numbers — battery, bulbs, filters and belts.

From the factory this vehicle uses a BCI 65 · 650 CCA battery. Each part links to every other vehicle that shares it, so a part you already stock may fit more of your fleet than you'd expect.

Battery groupBCI 65 · 650 CCAOEM · verified

Tire sizeP225-60R16OEM · verified

Wheel / rim7-JJ inOEM · verified

Full specifications

Engine, drivetrain, dimensions and economy.

Engine & drivetrain NHTSA vPIC

Transmission

Automatic 4-spd

Dimensions & weight NHTSA vPIC

Overall length	207.1 in
Overall width	74.8 in
Overall height	53.5 in
Wheelbase	113 in
Curb weight	3768 lb
Track (front / rear)	61.8 / 60.2 in
Weight distribution (front / rear)	59/41

Ratings & economy EPA / vPIC

EPA city / highway / combined	16 / 24 / 19 mpg
Drivetrain	Rear-Wheel Drive
Recommended fuel	Premium Gasoline

Performance & power Independent road tests

0–60 mph, quarter-mile, horsepower and torque from independent road tests.

Independent road tests for the Mark VIII of this era, listed by trim and engine — this page spans more than one engine, so no single horsepower figure is shown.

7.2 sec0–60 mph (tested)quickest 7.20 sec — 1996 LSC Coupe

Year	Trim / engine	0–60	¼ mile	HP	Drivetrain
1996	LSC Coupe 4.6L V8	7.20 sec	15.40 sec	280 hp	RWD
1997	LSC Coupe 4.6L V8	7.00 sec	15.30 sec	290 hp	RWD
1993	Coupe 4.6L V8	6.60 sec	14.90 sec	280 hp	RWD
1993	Coupe 4.6L V8	6.80 sec	15.30 sec	280 hp	RWD

Service quick specs OEM factory data

Capacities, torques and tune-up values from the factory service manual.

This engine holds 6.0 qt of 5W-20 API engine oil, DOT 3 brake fluid. Torque lug nuts to 85-105 ft-lbs, the oil drain plug to 19.0 ft-lbs. The firing order is 1-3-7-2-6-5-4-8. Note the cylinder-head bolts finish on a torque angle (torque-to-yield) — they stretch permanently and should be replaced, not reused, during any head service.

Lubricants & capacities

Brake Fluid	DOT 3
Engine Coolant	ETHYLENE GLYCOL
Engine Oil	5W-20 · API
Engine Oil Capacity	6.0 qt
Power Steering Fluid	ATF

Engine torques

Crankshaft Pulley and/or Damper Bolts	114-121 ft-lbs
Exhaust Manifold to Cylinder Head Bolts	14.0-16.0 ft-lbs
Oil Pan to Block Bolts	15.0-22.0 ft-lbs
Engine Oil Pan Drain Plug	8.0-12.0 ft-lbs
Engine Oil Pan Drain Plug	19.0 ft-lbs
Engine Valve Cover Bolts	6.0-8.8 ft-lbs

Chassis torques

Lug Nuts	85-105 ft-lbs
Steering Track (Rod End) Bolts	23.0-25.0 ft-lbs

Ignition

Cylinder Firing Order	1-3-7-2-6-5-4-8
Curb Idle Speed (No Load)	900 rpm
Curb Idle Speed Variance (No Load)	25 rpm
Curb Idle Speed (No Load)	700 rpm
Curb Idle Speed Variance (No Load)	50 rpm
Spark Plug Manufacturer	Motorcraft
Spark Plug Gap	0.052-0.056 in
Spark Plug Torque	11.0 ft-lbs

Battery & A/C

Refrigerant	R134a
Refrigerant Capacity	2.10-2.40 lbs
Oil Group	PAG
Oil Type	YN-12-D
Oil Capacity	7.00 oz
Standard BCI Group Number	65
Standard BCI Cranking Performance	650 cca
Optional BCI Group Number	65 - CANADA OR OPTIONAL

Service checks

Pressure Test	13-18 psi
Radiator Cap Pressure Relief	13-18 psi
Thermostat Opening Temperature	183-190 °F
Injector Primary Resistance	11-18 ohms

Brakes

Torque Caliper to Bracket	22-30 ft-lbs / 87 ft-lbs
Torque to Knuckle	72-97 ft-lbs / 85-105 ft-lbs
Minimum Pad Thickness	Front: 0.125; Rear: 0.125 in
Minimum Shoe Thickness	0.030
Rotor Max Parallel Variation	0.00035 in
Rotor Runout Limit	0.003 in / 0.002 in
Rotor Nominal Thickness From	1.024 in / 0.709 in
Rotor Nominal Thickness To	1.024 in / 0.709 in

Multi-step torque procedures OEM · verified

Cylinder Head — tightening sequence 6 stages

Prep Do not reuse old bolts. Coat new bolts lightly with specified oil

1	28.0-31.0 ft. lbs.	28–31 ft. lbs
2	85-95 degrees	85–95 degrees
3	Loosen all bolts completely.
4	28.0-31.0 ft. lbs.	28–31 ft. lbs
5	85-95 degrees	85–95 degrees
6	85-95 degrees	85–95 degrees

Factory maintenance schedule OEM · verified

Normal service, condensed from the factory interval matrix.

Under the factory schedule, replace the engine oil and filter every 5,000 mi; spark plugs every 100,000 mi; coolant every 30,000 mi. The big-interval services (every 30,000 mi for coolant, and the transmission fluid) are the ones owners most often skip — on a lower-mileage example, assume the original fluids are still in it and check them first.

At 5,000 mi	Tire & Wheel Assembly (rotate)
Every 5,000 mi	Engine Oil (drain & refill) · Engine Oil Filter (replace)
Every 10,000 mi	Tire & Wheel Assembly (rotate)
Every 15,000 mi	Steering Linkage (inspect) · Suspension System (inspect)
Every 30,000 mi	Accessory Drive Belt (inspect) · Brake Linings (inspect) · Engine Air Filter Element (replace) · Engine Coolant System (drain, flush & refill) · Exhaust System Heat Shield (inspect) · Transmission Assembly (drain & refill)
At 50,000 mi	Engine Coolant System (drain, flush & refill)
At 60,000 mi	Accessory Drive Belt (inspect)
Every 100,000 mi	Drive Axle Assembly (drain & refill) · PCV Valve (replace) · Spark Plugs (replace)

Reliability & federal safety record

Owner-reported issues, recalls, investigations and service bulletins on record with NHTSA — an unfiltered look at what owners actually experience.

In 1996, the Lincoln Mark VIII received 111 complaints, a noticeable drop from the 157 complaints in 1995, and it matched the two recalls that occurred in 1995 and 1996. The year saw zero investigations and 34 total safety bulletins, slightly higher than the 28 in 1995 but lower than the 82 in 1997. Compared to the following years, complaints continued to fall through 1998 (86) and sharply to 2 in 1999, while recalls remained at two until 1999 when none were issued. The 1996 model’s complaint distribution—78 on exterior lighting, 6 on vehicle speed control, 4 on electrical, and 4 on power train—shows lighting as the dominant issue, a trend that persists but lessens in subsequent years. With only 5 crash and 2 fire complaints, the 1996 year sits near the midpoint of a downward trend in overall complaints, suggesting a relatively stable period in the generation’s lifespan. Overall, 1996 represents a solid purchase year, though buyers should be mindful of lighting-related concerns.

Open recalls

NHTSA campaigns

Service bulletins

Manufacturer communications

ODI investigations

Office of Defects Investigation

111

Owner complaints

5 involved a crash · 2 a fire

Owner complaints by model year NHTSA · this generation & adjacent

’95’96’97 ’98 ’99 ’00

Owner complaints filed with NHTSA, by component

All 111 complaints on record, top 8 components.

Exterior Lighting78

Vehicle Speed Control6

Electrical System4

Power Train4

Tires2

Air Bags2

Wheels2

Service Brakes, Hydraulic,Exterior Lighting2

Source: NHTSA Office of Defects Investigation complaint database.

Recalls NHTSA · verified

Showing 2 of 2 campaigns on record for this vehicle.

16E026000Service Brakes, Hydraulic:Foundation Components:Disc:PadsReported 01/04/2016

Bosch Brake Components LLC (Bosch) is recalling certain aftermarket replacement front brake pads, models Bosch QuietCast BC598 and BP765, Bosch Blue BE598 and BE598H, Prostop PD598 and PD765M, Duralast Gold DG598… Remedy: Bosch will instruct the owners how to have the affected brake pads replaced, free of charge. The recall began on May 26, 2016. Owners may contact Bosch customer service at…

07V336000Vehicle Speed ControlReported 03/08/2007

ON CERTAIN PICKUP TRUCKS, PASSENGER VEHICLES, SPORT UTILITY VEHICLES, AND MOTOR HOMES CHASSIS, THE SPEED CONTROL DEACTIVATION SWITCH MAY, UNDER CERTAIN CONDITIONS, LEAK INTERNALLY AND THEN OVERHEAT, SMOKE, OR BURN. Remedy: DEALERS WILL INSTALL A FUSED WIRING HARNESS. OWNERS OF THE PASSENGER CARS INCLUDED IN THIS CAMPAIGN WILL BE INSTRUCTED TO RETURN THEIR VEHICLES TO THEIR DEALERS TO HAVE THE SPEED…

Technical service bulletins NHTSA · verified

Showing 5 of 34 bulletins on record with NHTSA.

Bulletin	Date	Component	Summary
03181	2003-09-15	Electrical System	REMOTE KEYLESS ENTRY (RKE) - SERVICE TIPS. *TT
03148	2003-07-21	Power Train	NEW TRANSMISSION COOLER FLUSHER - SERVICE TIPS. 2003 ESCORT AND SUPER DUTY F SERIES…
03261	2003-01-05	Power Train	NEW SERVICE PART - NUMBER 5 NEEDLE BEARING AND RACE KIT - 4R70W TRANSMISSION - SERVICE…
02208	2002-10-14	Equipment	CLIMATE CONTROL A/C SERVICE TECH TIPS. *EH
02176	2002-09-02	Exterior Lighting	LAMP-BRAKE-INVADVERTENT DISABLING OF BRAKE SHIFT INTERLOCK. *MJ

Common OBD-II trouble codes

The most common OBD-II codes for this vehicle's emissions system. These are standardized SAE J2012 definitions, not vehicle-specific fault reports.

P0420

Catalyst system efficiency below threshold — Bank 1

P0300

Random / multiple cylinder misfire detected

P0171

System too lean — Bank 1

P0455

Evaporative emission system leak detected — large leak

P0128

Coolant thermostat below regulating temperature

P0442

Evaporative emission system leak detected — small leak

VIN tools

Decode factory build data for a specific vehicle by VIN.

VIN

Decode a VIN to confirm the transmission and build data for a specific Mark VIII. OEM

Build data

Plant, GVWR class, engine and body data for any 17-character VIN.

Recalls

Check open recall campaigns against a specific vehicle by VIN.

Vehicles with shared specs

Find every vehicle that shares this one's battery, bulbs, oil capacity, platform or parts.

Group 65 battery Vehicles taking 6.0 qt

Reference guides

Cross-vehicle references for the kinds of data on this page.

Vehicle recalls & TSBs OBD-II trouble codes Torque specifications Maintenance schedules Fluid capacities & specs

Frequently asked

How much oil does the 1996 Mark VIII take?

6.0 qt of 5W-20 API, per the factory manual.

Does the 1996 Mark VIII have open recalls?

NHTSA lists 2 recall campaign(s) for this model year. Check your specific vehicle by VIN.

What gas mileage does the Mark VIII get?

EPA figures are 16 city / 24 highway / 19 combined mpg.