Land Rover›Defender›2013›Overview/land-rover/defender/2013/base/

2013 Land Rover Defender

Factory specifications, fluid capacities, torque values, EPA fuel economy and the federal safety record for the 2013 Defender.

Model year2016 2013

Performance & power Independent road tests

0–60 mph, quarter-mile, horsepower and torque from independent road tests.

Independent road tests for the Defender of this era, listed by trim and engine — this page spans more than one engine, so no single horsepower figure is shown.

9.8–12.3 sec0–60 mph (tested)quickest 9.80 sec — 1997 90 3-door Hardtop

Year	Trim / engine	0–60	¼ mile	HP	Drivetrain
1997	90 3-door Hardtop 3.9L V8	9.80 sec	17.60 sec	182 hp	4x4
1995	90 3-door Hardtop 3.9L V8	10.30 sec	17.80 sec	182 hp	4x4
1994	90 3-door 3.9L V8	10.20 sec	17.60 sec	182 hp	4x4
1993	110 5-door 3.9L V8	12.30 sec	18.80 sec	182 hp	4x4

Common OBD-II trouble codes

The most common OBD-II codes for this vehicle's emissions system. These are standardized SAE J2012 definitions, not vehicle-specific fault reports.

Catalyst system efficiency below threshold — Bank 1

Random / multiple cylinder misfire detected

System too lean — Bank 1

Evaporative emission system leak detected — large leak

Coolant thermostat below regulating temperature

Evaporative emission system leak detected — small leak

VIN tools

Decode factory build data for a specific vehicle by VIN.

VIN

Decode a VIN to confirm the transmission and build data for a specific Defender. OEM

Build data

Plant, GVWR class, engine and body data for any 17-character VIN.

Recalls

Check open recall campaigns against a specific vehicle by VIN.

Reference guides

Cross-vehicle references for the kinds of data on this page.

OBD-II trouble codes