Factory specifications, fluid capacities, torque values, EPA fuel economy and the federal safety record for the 2014 Fit.
The 2014 Honda Fit takes 3.8 qt of 0W-20 engine oil.
Fluid capacities, tune-up values and fuel economy at a glance.
Replacement part sizes and factory part numbers — battery, bulbs, filters and belts.
From the factory this vehicle uses a BCI 151R · 340 CCA battery. Each part links to every other vehicle that shares it, so a part you already stock may fit more of your fleet than you'd expect.
Engine, drivetrain, dimensions and economy.
| Overall length | 161.8 in |
| Overall width | 66.9 in |
| Overall height | 59.8 in |
| Wheelbase | 98.4 in |
| Curb weight | 2564 lb |
| Track (front / rear) | 59.1 / 57.9 in |
| Weight distribution (front / rear) | 62/38 |
0–60 mph, quarter-mile, horsepower and torque from independent road tests.
Independent road tests for the Fit of this era, listed by trim and engine — this page spans more than one engine, so no single horsepower figure is shown.
| Year | Trim / engine | 0–60 | ¼ mile | HP | Drivetrain |
|---|---|---|---|---|---|
| 2013 | EV Hatchback Elec 20-kWh | 8.50 sec | 16.70 sec | 123 hp | FWD |
| 2013 | EV Hatchback (Sport Mode) Elec 20-kWh | 8.70 sec | 16.80 sec | 123 hp | FWD |
| 2012 | Sport Hatchback 1.5L I-4 | 8.20 sec | 16.30 sec | 117 hp | FWD |
| 2011 | Sport Hatchback 1.5L I-4 | 8.40 sec | 16.50 sec | 117 hp | FWD |
| 2010 | Sport Hatchback 1.5L I-4 | 8.30 sec | 16.50 sec | 117 hp | FWD |
| 2010 | Sport Hatchback 1.5L I-4 | 10.20 sec | 17.60 sec | 117 hp | FWD |
| 2009 | Sport Hatchback 1.5L I-4 | 8.30 sec | 16.30 sec | 117 hp | FWD |
| 2009 | Sport Hatchback 1.5L I-4 | 8.50 sec | 16.60 sec | 117 hp | FWD |
Capacities, torques and tune-up values from the factory service manual.
This engine holds 3.8 qt of 0W-20 API engine oil, DOT 3 brake fluid. Torque lug nuts to 80 ft-lbs, the oil drain plug to 29.0 ft-lbs. The firing order is 1-3-4-2.
| Automatic Transmission Fluid | ATF |
| Brake Fluid | DOT 3 |
| Engine Oil | 0W-20 · API |
| Engine Oil Capacity | 3.8 qt |
| Engine Flywheel Bolts | 87 ft-lbs |
| Engine Oil Pan Drain Plug | 29.0 ft-lbs |
| Oil Pump to Cylinder BLock Bolts/Studs | 7 ft-lbs |
| Lug Nuts | 80 ft-lbs |
| Automatic Transmission Drain Plug | 36.0 ft-lbs |
| Cylinder Firing Order | 1-3-4-2 |
| Ignition Timing | 0 degrees |
| Ignition Timing Acceptable Variance | 2 degrees |
| Ignition Timing Reference RPM | Idle rpm |
| Refrigerant | R134a |
| Refrigerant Capacity | .81-.92 lbs |
| Oil Group | PAG |
| Oil Type | 46 |
| Oil Capacity | 2.66-3.00 oz |
| Refrigerant | R1234yf |
| Refrigerant Capacity | 0.83-0.95 lbs |
| Oil Type | ND 11 Oil |
| Engine Compression | 142 Minimum PSI. 29 Maximum variation PSI |
| Torque Caliper to Bracket | 17 ft-lbs |
| Torque to Knuckle | 80 ft-lbs |
| Minimum Pad Thickness | 0.063 in |
| Minimum Shoe Thickness | 0.039 in |
| Drum Nominal Diameter | 7.874 in |
| Drum Discard at-or-over | 7.913 |
| Rotor Max Parallel Variation | 0.0006 in |
| Rotor Runout Limit | 0.0016 in |
| 1 | 7 ft. lbs., Step 2: 90 | 7 ft. lbs |
| 1 | 27 ft. lbs., step 2: 90 | 27 ft. lbs |
| 1 | 18 ft. lbs., Step 2: 40 | 18 ft. lbs |
Normal service, condensed from the factory interval matrix.
| Every 7,500 mi | Tire & Wheel Assembly (rotate) |
| Every 15,000 mi | Brake Line (inspect) · Brake System (inspect) · CV Joint Boot (inspect) · Parking Brake System (inspect) · Steering Gear Box Assembly (inspect) · Suspension System (inspect) |
| Every 30,000 mi | Cabin Air Filter (replace) |
The most common OBD-II codes for this vehicle's emissions system. These are standardized SAE J2012 definitions, not vehicle-specific fault reports.
Decode factory build data for a specific vehicle by VIN.
Find every vehicle that shares this one's battery, bulbs, oil capacity, platform or parts.
Cross-vehicle references for the kinds of data on this page.
3.8 qt of 0W-20 API, per the factory manual.