Factory specifications, fluid capacities, torque values, EPA fuel economy and the federal safety record for the 1975 Civic.
The 1975 Honda Civic Overview represents the early entry of Honda’s subcompact line, though the supplied data does not detail its body style, platform or engine specifications. Complaint records for the model span 1990 through 2022, showing the lowest reported issues in 1990 with 102 complaints and a peak in 2006 at 1,402 complaints. Because the complaint history begins after the 1975 model year, this dataset offers no direct insight into the 1975 Civic’s reliability position within the broader trend. Consequently, any assessment of its dependability must rely on sources outside the provided information.
Engine, drivetrain, dimensions and economy.
| Overall length | 146.9 in |
| Overall width | 59.1 in |
| Overall height | 52 in |
| Wheelbase | 86.6 in |
| Curb weight | 1631 lb |
0–60 mph, quarter-mile, horsepower and torque from independent road tests.
Independent road tests for the Civic of this era, listed by trim and engine — this page spans more than one engine, so no single horsepower figure is shown.
| Year | Trim / engine | 0–60 | ¼ mile | HP | Drivetrain |
|---|---|---|---|---|---|
| 1975 | CVCC 3-door Hatchback 1.5L I-4 | 15.60 sec | 20.10 sec | 53 hp | FWD |
| 1975 | CVCC 3-door Hatchback 1.5L I-4 | 17.40 sec | 21.00 sec | 53 hp | FWD |
| 1973 | 3-door Hatchback 1.2L I-4 | 12.90 sec | 18.70 sec | 50 hp | FWD |
| 1979 | CVCC Wagon 1.5L I-4 | 15.50 sec | 20.10 sec | 67 hp | FWD |
Owner-reported issues, recalls, investigations and service bulletins on record with NHTSA — an unfiltered look at what owners actually experience.
Showing 2 of 2 campaigns on record for this vehicle.
PROLONGED CONTACT WITH ROAD SALT MAY, UNDER CERTAIN CONDITIONS, CAUSE SERIOUS RUSTING. THIS CAN WEAKEN CERTAIN UNDERCARRIAGE COMPONENTS: LATERAL SUSPENSION ARMS, FRONT CROSSBEAM AND STRUT COIL SPRING LOWER SUPPORTS. Remedy: VEHICLES WILL BE INSPECTED AND, IF NECESSARY, TREATED WITH A RUST PREVENTIVE COATING. IN SOME CASES, REPLACEMENT OF COMPONENTS WILL BE PERFORMED, WITHOUT CHARGE TO OWNER.
THE INTERNAL MUFFLER PRESSURE CAN CREATE A SPLIT IN THE SEAM IF THE MUFFLER IS IN A DETERIORATED CONDITION. IF THIS CONDITION EXISTS, THE EXHAUST GAS ESCAPING FROM THE SPLIT SEAM CAN CAUSE EXCESSIVE HEATING OF A SMALL… Remedy: DEALER WILL INSTALL A MUFFLER COVER TO PREVENT EXCESSIVE FLOOR TEMPERATURES IN CASE OF MUFFLER SEAM SPLITTING.
The most common OBD-II codes for this vehicle's emissions system. These are standardized SAE J2012 definitions, not vehicle-specific fault reports.
Decode factory build data for a specific vehicle by VIN.
Cross-vehicle references for the kinds of data on this page.
NHTSA lists 2 recall campaign(s) for this model year. Check your specific vehicle by VIN.