Factory specifications, fluid capacities, torque values, EPA fuel economy and the federal safety record for the 1975 D300.
Identified as the 1975 Dodge D300, this vehicle presents a reliability profile defined by three recalls and a single total owner complaint. The sole grievance cites structure as the top complaint area, focusing attention on the vehicle's build for researchers examining this specific model year. This sparse reporting history situates the model year uniquely within the model's reliability history, suggesting a period where owner-reported issues were minimal despite the recorded recall activity.
Condensed service procedures for routine maintenance. Procedures that require dealer diagnostic equipment are identified and summarized only.
| Tool required | DRBIII scan tool (dealer / locksmith) |
| Why | Transmitter codes are written into the receiver in the passenger door module |
| When needed | After Sentry Key Immobilizer Module (SKIM) replacement |
| Tool required | DRBIII scan tool |
| Also required | The vehicle's four-digit PIN code |
Owner-reported issues, recalls, investigations and service bulletins on record with NHTSA — an unfiltered look at what owners actually experience.
Owner complaints about the 1975 Dodge D300 dominate in one area — the structure, 1 of 1 reports (100%), well ahead of the next concern. That matters, because the structure are also the target of recall 80V-027 on this vehicle — so the single most useful check before buying or servicing one is confirming it was actually performed. 0 of the reports describe a crash and 0 a fire — a small share of the total, but worth weighing against the structure pattern above. These are tallies of what owners actually reported to the federal government, not an editorial score — and higher-selling models naturally rack up more reports.
All 1 complaints on record, top 1 components.
Source: NHTSA Office of Defects Investigation complaint database.
Showing 2 of 3 campaigns on record for this vehicle.
DUE TO A COMBINATION OF DISC BRAKE PAD WEAR AND TURN STOP WEAR ON CERTAIN VEHICLES, THERE MAY BE AN INCREASE IN BRAKE PEDAL TRAVEL AND A REDUCTION IN FRONT BRAKING EFFECTIVENESS FOLLOWING A FULL TURN. ALSO, A FRAME… Remedy: UPON INSPECTION DEALER WILL REPLACE EITHER THE LEFT OR RIGHT TURN STOP BRACKET TO CORRECT THE FRONT BRAKES. IF FRAME IS CRACKED IT WILL BE WELDED AND A ROD REINFORCEMENT WILL BE…
THE FRONT RAIL EXTENSION MAY EXPERIENCE FATIGUE CRACKING NEAR THE AREA WHERE THE POWER STEERING GEAR ATTACHES TO THE FRAME. IF THE CRACK PROGRESSES THROUGH MOST OR ALL OF THE RAIL SECTION, STEERING SYSTEM FREE PLAY… Remedy: AFFECTED VEHICLES WILL BE WELD REPAIRED AND A REINFORCEMENT ROD WILL BE INSTALLED OVER THE CRACKED AREA.
The most common OBD-II codes for this vehicle's emissions system. These are standardized SAE J2012 definitions, not vehicle-specific fault reports.
Decode factory build data for a specific vehicle by VIN.
Cross-vehicle references for the kinds of data on this page.
NHTSA lists 3 recall campaign(s) for this model year. Check your specific vehicle by VIN.