Factory specifications, fluid capacities, torque values, EPA fuel economy and the federal safety record for the 1984 D250.
The 1984 Dodge D250 is the model under review in this reference, and the supplied specification set is limited to engine-oil service: the crankcase takes 5 quarts with the filter, using one of three approved viscosities—20W-20, 15W-40, or 5W-30. Those lubrication figures are the only hard service data provided here, with no powertrain, chassis, or reliability context included. As a result, this page cannot place the 1984 D250 within any broader model reliability history; it serves strictly as a maintenance baseline for oil capacity and viscosity selection.
Fluid capacities, tune-up values and fuel economy at a glance.
Capacities, torques and tune-up values from the factory service manual.
This engine holds 5 qt w/ filter of 20W-20 / 15W-40 / 5W-30 engine oil, Front: 90 in the differential.
| Differential Gear Oil | Front: 90 |
| Differential Gear Oil Capacity | 4 Pints, |
| Engine Coolant | ETHYLENE GLYCOL |
| Engine Oil | 20W-20 · 15W-40 · 5W-30 · 5W-40 |
| Engine Oil Capacity | 5 qt w/ filter |
| Engine Oil | 20W-20 · 15W-40 · 5W-30 · 5W-40 |
| Engine Oil Capacity | 5 qt w/ filter |
| Power Steering Fluid | USE MOPAR PART NO. 4318055 OR EQUIVALENT |
Condensed service procedures for routine maintenance. Procedures that require dealer diagnostic equipment are identified and summarized only.
| Tool required | DRBIII scan tool (dealer / locksmith) |
| Why | Transmitter codes are written into the receiver in the passenger door module |
| When needed | After Sentry Key Immobilizer Module (SKIM) replacement |
| Tool required | DRBIII scan tool |
| Also required | The vehicle's four-digit PIN code |
Owner-reported issues, recalls, investigations and service bulletins on record with NHTSA — an unfiltered look at what owners actually experience.
No recall campaigns on record with NHTSA for this vehicle as of the last data refresh.
The most common OBD-II codes for this vehicle's emissions system. These are standardized SAE J2012 definitions, not vehicle-specific fault reports.
Decode factory build data for a specific vehicle by VIN.
Find every vehicle that shares this one's battery, bulbs, oil capacity, platform or parts.
Cross-vehicle references for the kinds of data on this page.
5 qt w/ filter of ABOVE 20 degrees F: 30, 20 degrees F TO 80 degrees F: 20W-20, ABOVE 10 degrees F: 15W-40, BELOW 100 degrees F 5W-30 OR 5W-40, BELOW 60 degrees F: 5W-30, 5W-40, per the factory manual.
NHTSA lists 0 recall campaign(s) for this model year. Check your specific vehicle by VIN.