Factory maintenance schedule OEM · verified
Normal service, condensed from the factory interval matrix.
| Every 100,000 mi | Oxygen Sensor (replace) |
Factory specifications, fluid capacities, torque values, EPA fuel economy and the federal safety record for the 2000 Z8.
The 2000 BMW Z8, built on the E52 chassis, pairs a naturally aspirated V8 with a 7.9‑quart oil capacity—requiring 15W‑40, 10W‑40, or 10W‑30 API SJ lubricants—and is mated to a 6‑speed manual gearbox. It achieves EPA‑rated 12 mpg city, 19 mpg highway, and 15 mpg combined, reflecting the balance of power and efficiency characteristic of this high‑performance roadster.
Fluid capacities, tune-up values and fuel economy at a glance.
Replacement part sizes and factory part numbers — battery, bulbs, filters and belts.
From the factory this vehicle uses a BCI 49 · 850 CCA battery, OE oil filter 11421741000. Each part links to every other vehicle that shares it, so a part you already stock may fit more of your fleet than you'd expect.
| Engine oil filter | 11421741000 alt 11427510717 |
| Engine air filter | 13721736675 |
| Spark plug | 12120037608 alt 12129071003 |
| Cabin air filter | 64312339891 alt 64116911691 |
Engine, drivetrain, dimensions and economy.
| Transmission | Manual 6-spd |
| EPA city / highway / combined | 12 / 19 / 15 mpg |
| Drivetrain | Rear-Wheel Drive |
| Recommended fuel | Premium Gasoline |
0–60 mph, quarter-mile, horsepower and torque from independent road tests.
Independent road tests for the Z8 of this era, listed by trim and engine — this page spans more than one engine, so no single horsepower figure is shown.
| Year | Trim / engine | 0–60 | ¼ mile | HP | Drivetrain |
|---|---|---|---|---|---|
| 2000 | Roadster 4.9L V8 | 4.20 sec | 12.60 sec | 394 hp | RWD |
| 2000 | Roadster 4.9L V8 | 4.50 sec | 13.00 sec | 394 hp | RWD |
| 2001 | Roadster 4.9L V8 | 4.30 sec | 12.90 sec | 394 hp | RWD |
| 2001 | Roadster 4.9L V8 | 4.60 sec | 13.00 sec | 394 hp | RWD |
| 2001 | Roadster 4.9L V8 | 4.69 sec | 12.84 sec | 394 hp | RWD |
Capacities, torques and tune-up values from the factory service manual.
This engine holds 7.9 qt of 15W-40 / 10W-40 / 10W-30 API SJ engine oil. Torque lug nuts to 88 ft-lbs, the oil drain plug to 22.0 ft-lbs. The firing order is 1-5-4-8-6-3-7-2. Note the cylinder-head bolts finish on a torque angle (torque-to-yield) — they stretch permanently and should be replaced, not reused, during any head service.
| Differential Gear Oil Capacity | 3 Pints |
| Engine Oil | 15W-40 · API · 10W-40 · 10W-30 · 5W-30 |
| Engine Oil Capacity | 7.9 qt |
| Power Steering Fluid | ATF |
| Engine Oil Pan Drain Plug | 22.0 ft-lbs |
| Lug Nuts | 88 ft-lbs |
| Rear Wheel Hub | 221 ft-lbs |
| Cylinder Firing Order | 1-5-4-8-6-3-7-2 |
| Spark Plug Manufacturer | BMW |
| Refrigerant | R134a |
| Oil Group | PAG |
| Oil Type | 46 |
| Standard BCI Group Number | 49 |
| Standard BCI Cranking Performance | 850 cca |
| Pressure Test | 21.7 psi |
| Radiator Cap Pressure Relief | 28-32 psi |
| Thermostat Opening Temperature | 174 °F |
| Injector Primary Resistance | 15-17 ohms |
| Engine Compression | 174-203 psi |
| Engine Oil Pressure | 7.25 |
| Intake Valve Lash | Hydraulic in |
| Exhaust Valve Lash | Hydraulic in |
| Torque Caliper to Bracket | 81 ft-lbs / 18-22 ft-lbs |
| Torque to Knuckle | 81-96 ft-lbs / 49 ft-lbs |
| Minimum Pad Thickness | Front: 0.079; Rear: 0.079 in |
| Rotor Discard at or Under | 1.197 in / 0.724 in |
| Rotor Finish | 0.5 - 3.5 μin |
| 1 | 22 ft. lbs. | 22 ft. lbs |
| 2 | 80 degrees | 80 degrees |
| 3 | 80 | |
Normal service, condensed from the factory interval matrix.
| Every 100,000 mi | Oxygen Sensor (replace) |
Owner-reported issues, recalls, investigations and service bulletins on record with NHTSA — an unfiltered look at what owners actually experience.
No recall campaigns on record with NHTSA for this vehicle as of the last data refresh.
Showing 5 of 13 bulletins on record with NHTSA.
| Bulletin | Date | Component | Summary |
|---|---|---|---|
| B067124 | 2024-09-19 | Engine | Thermostat Return |
| SIB-63-02-01 | 2010-08-01 | Exterior Lighting | BMW: PROCEDURE FOR DETERMINING AND REPLACING INCANDESCENT AND HALOGEN LIGHT BULBS UNDER… |
| SI B12 12 10 | 2010-06-01 | Engine And Engine Cooling | BMW: WHEN AT LOWER SPEEDS OR STOPPING THE ENGINE IDLE DIPS TOO LOW BECAUSE OF A SOFTWARE… |
| SIB-32-04-07 | 2010-06-01 | Steering | BMW: A NEW TECHNICAL PROCESS HAS BEEN CREATED FOR BMW TO IDENTIFY CAUSES OF STEERING… |
| SIB-16-02-09 | 2009-12-01 | Fuel System, Gasoline | BMW VEHICLES: FUEL LEVEL SENSOR REPAIRS. WHERE IT IS NECESSARY TO REPLACE THE RIGHT OR… |
The most common OBD-II codes for this vehicle's emissions system. These are standardized SAE J2012 definitions, not vehicle-specific fault reports.
Decode factory build data for a specific vehicle by VIN.
Find every vehicle that shares this one's battery, bulbs, oil capacity, platform or parts.
Cross-vehicle references for the kinds of data on this page.
7.9 qt of HIGH PERFORMANCE MINERAL OILS: ABOVE 5 degrees F: 15W-40 API SJ, SL OR SM, -5 degreesF TO 68 degrees F: 10W-40 API SJ, SL OR SM, 5 degreesF TO 50 degrees F: 10W-30 API SJ, SL OR SM, BELOW 50 degrees F: 5W-30 API SJ, SL OR SM, BELOW 32 degrees F:, per the factory manual.
NHTSA lists 0 recall campaign(s) for this model year. Check your specific vehicle by VIN.
EPA figures are 12 city / 19 highway / 15 combined mpg.