Factory specifications, fluid capacities, torque values, EPA fuel economy and the federal safety record for the 2007 M Coupe.
The 2007 BMW M Coupe.
Fluid capacities, tune-up values and fuel economy at a glance.
Replacement part sizes and factory part numbers — battery, bulbs, filters and belts.
From the factory this vehicle uses a BCI 47 · 480 CCA battery, OE oil filter 11428683168. Each part links to every other vehicle that shares it, so a part you already stock may fit more of your fleet than you'd expect.
| Engine oil filter | 11428683168 alt 11421741000 |
| Engine air filter | 13717521033 alt 13717542545 |
| Fuel filter | 16117168284 |
| Spark plug | 12120022902 alt 12122158253 |
| Battery | 61217586960 alt 61217586961 |
| Front wiper blades | 61617054622 alt 61617079659 |
| Thermostat | 11531318402 alt 11531318274 |
| Cabin air filter | 64319195194 |
Engine, drivetrain, dimensions and economy.
| Overall length | 161.8 in |
| Overall width | 70.1 in |
| Overall height | 50.8 in |
| Wheelbase | 98.4 in |
| Curb weight | 3230 lb |
| Track (front / rear) | 58.3 / 59.1 in |
| Weight distribution (front / rear) | 52/48 |
Capacities, torques and tune-up values from the factory service manual.
This engine DOT 4 brake fluid. Torque lug nuts to 88 ft-lbs, the oil drain plug to M12 Bolts: 18.0, M22 Bolts: 44.0 ft-lbs. The firing order is 1-5-3-6-2-4. Note the cylinder-head bolts finish on a torque angle (torque-to-yield) — they stretch permanently and should be replaced, not reused, during any head service.
| Brake Fluid | DOT 4 |
| Differential Gear Oil Capacity | 2.1 Pints |
| Differential Gear Oil Capacity | 2.5 Pints |
| Engine Coolant | ETHYLENE GLYCOL |
| Engine Oil | SYNTHETIC |
| Engine Oil Capacity | 6.9 qt |
| Engine Oil | SYNTHETIC |
| Engine Oil Capacity | 5.8 qt |
| Crankshaft Pulley and/or Damper Bolts | 18 ft-lbs |
| Engine Flywheel Bolts | AT: 92 ft-lbs, MT: 89 ft-lbs |
| Engine Oil Pan Drain Plug | M12 Bolts: 18.0, M22 Bolts: 44.0 ft-lbs |
| Lug Nuts | 88 ft-lbs |
| Cylinder Firing Order | 1-5-3-6-2-4 |
| Spark Plug Manufacturer | BMW |
| Refrigerant | R134a |
| Refrigerant Capacity | 1.26-1.90 lbs |
| Oil Group | PAG |
| Oil Type | 46 |
| Oil Capacity | 4.70-6.00 oz |
| Standard BCI Group Number | 47 |
| Standard BCI Cranking Performance | 480 cca |
| Optional BCI Group Number | 94R |
| Pressure Test | 29.0 psi |
| Radiator Cap Pressure Relief | 26-30 psi |
| Thermostat Opening Temperature | 207 °F |
| Engine Compression | 130-261 PSI. 29 maximum variation. psi |
| Engine Compression | 159-174 PSI. |
| Torque Caliper to Bracket | 18-22 ft-lbs |
| Torque to Knuckle | 81 ft-lbs / 49 ft-lbs |
| Minimum Pad Thickness | Front: 0.145; Rear: 0.145 pads |
| Rotor Nominal Thickness From | 0.866 in / 0.75 in |
| Rotor Nominal Thickness To | 0.866 in / 0.75 in |
| Rotor Minimum Machining | 0.031 in |
| Rotor Discard at or Under | 0.803 in / 0.685 in |
| Rotor Finish | 0.5 - 3.5 μin |
| 1 | 15 ft. lbs., Step 2: 120 | 15 ft. lbs |
| 1 | 44 ft. lbs., step 2: 50 degrees, step 3: 50 | 44 ft. lbs |
| 1 | 25-29 ft. lbs. | 25–29 ft. lbs |
| 2 | 90 degrees | 90 degrees |
| 3 | 90 | |
| 1 | 22 ft. lbs. | 22 ft. lbs |
| 2 | 90 degrees | 90 degrees |
| 3 | bolt 1-10 | 90 degrees |
| 4 | all turn 90 | |
| 1 | 15 ft. lbs., Step 2: 70 | 15 ft. lbs |
Normal service, condensed from the factory interval matrix.
Under the factory schedule, replace the spark plugs every 100,000 mi.
| Every 25,000 mi | Brake Linings (inspect) |
| Every 28,000 mi | Cabin Air Filter (inspect) |
| Every 30,000 mi | Engine Coolant System (leak inspection) |
| Every 31,000 mi | Brake System (inspect) |
| Every 100,000 mi | Oxygen Sensor (replace) · Spark Plugs (replace) · Transmission Assembly (drain & refill) |
The most common OBD-II codes for this vehicle's emissions system. These are standardized SAE J2012 definitions, not vehicle-specific fault reports.
Decode factory build data for a specific vehicle by VIN.
Find every vehicle that shares this one's battery, bulbs, oil capacity, platform or parts.
Cross-vehicle references for the kinds of data on this page.
6.9 qt of USE ONLY BMW HIGH PERFORMANCE SYNTHETIC MOTOR OIL BMW PART NO. 07510009420 OR EQUIVALENT, per the factory manual.