2017 Audi TTS Quattro

Factory specifications, fluid capacities, torque values, EPA fuel economy and the federal safety record for the 2017 TTS Quattro.

Fitment & sizes

Replacement part sizes and factory part numbers — battery, bulbs, filters and belts.

From the factory this vehicle uses OE oil filter 06L115562B. Each part links to every other vehicle that shares it, so a part you already stock may fit more of your fleet than you'd expect.

OE service part numbers OEM · verified

Engine oil filter	06L115562B
Engine air filter	5Q0129620B
Spark plug	06K905601B
Battery	000915089J alt 000915089BE
Front wiper blades	8S1998002
Serpentine belt	06L903137A
Cabin air filter	5Q0819669

Full specifications

Engine, drivetrain, dimensions and economy.

Dimensions & weight NHTSA vPIC

Overall length	165 in
Overall width	72 in
Overall height	52.8 in
Wheelbase	98.8 in
Curb weight	3274 lb
Track (front / rear)	61.8 / 61 in
Weight distribution (front / rear)	60/40

Service quick specs OEM factory data

Capacities, torques and tune-up values from the factory service manual.

This engine DOT 4 brake fluid. The firing order is 1-3-4-2. Note the cylinder-head bolts finish on a torque angle (torque-to-yield) — they stretch permanently and should be replaced, not reused, during any head service.

Lubricants & capacities

Brake Fluid	DOT 4
Power Steering Fluid	Use Audi/VW part number G004000M2

Engine torques

Crankshaft Position (CKP) Sensor Bolt(s)	7.4 ft-lbs
Camshaft Position (CMP) Sensor Bolt(s)	7.4 ft-lbs
Engine Coolant Temperature (ECT) Sensor Bolt(s)	7.4 ft-lbs
Oxygen (O2S) Sensor Bolt(s)	30.0 ft-lbs
Knock Sense (KS) Bolt(s)	14.75 ft-lbs
Intake Manifold to Engine Bolts	6.6 ft-lbs
Exhaust Manifold to Cylinder Head Bolts	18.4 ft-lbs
Nitrogen Oxide (NOX) Sensor Bolt(s)	35.0 ft-lbs

Chassis torques

Differential Fill Plug	18.0 ft-lbs
Differential drain Plug	18.0 ft-lbs
Transfer Case Fill Plug	9.0 ft-lbs
Transfer Case Drain Plug	9.0 if equipped with drain plug ft-lbs
Automatic Transmission Drain Plug	18.0-22.0 ft-lbs

Ignition

Cylinder Firing Order	1-3-4-2
Spark Plug Torque	22.0 ft-lbs

Service checks

Engine Compression

159-203 PSI @ RPM; 44 MAXIMUM VARIATION. psi

Brakes

Brake Caliper Bolt to Carrier Torque	Front: 22.0; Rear: 26 Use
Brake Caliper Carrier to Hub Bolt Torque	Front: 145; Rear: 75 use
ABS Sensor Torque	6.6
Vented Rotor Minimum Thickness for Replacement	Front w/1LJ and 1ZD:
Vented Rotor Minimum Thickness after Refinish	Stamped on rotor

Multi-step torque procedures OEM · verified

Connecting Rod (Large End) Bearings — tightening sequence 1 stages

Prep Gasoline engines

1	33.0 ft. lbs., Step 2: 90 degrees; Diesel engines	33 ft. lbs
1	22.0 ft. lbs., Step 2: 90	22 ft. lbs

Crankshaft Pulley and/or Damper Bolts — tightening sequence 1 stages

1

110.0 ft. lbs. Step 2: + 90

110 ft. lbs

Cylinder Head — tightening sequence 4 stages

Prep Do not re-use old bolts. · Long head bolts

1	Tighten all bolts finger tight.
2	30.0 ft. lbs.	30 ft. lbs
3	90 degrees	90 degrees
4	90 degrees; Short head bolts (located in front of head)	90 degrees
1	3.0 ft. lbs.	3 ft. lbs
2	90 degrees	90 degrees

Engine Flywheel Bolts — tightening sequence 2 stages

1	44.0 ft. lbs.	44 ft. lbs
2	90

Main Bearings — tightening sequence 1 stages

Prep Gas engines · Cap bolts: Step 1: 48.0 ft. lbs., Step 2: 90 degrees, Side bolts: Step 1: 15.0 ft. lbs., Step 2: 90 degrees · Diesel engines

1

48.0 ft. lbs., Step 2: 90

48 ft. lbs

Factory maintenance schedule OEM · verified

Normal service, condensed from the factory interval matrix.

Under the factory schedule, replace the engine oil and filter every 10,000 mi; spark plugs every 40,000 mi.

Every 10,000 mi	Brake System (inspect) · Engine Assembly (leak inspection) · Engine Oil (drain & refill) · Engine Oil Filter (replace) · Tire & Wheel Assembly (inspect) · Tire Pressure Monitoring System (reset)
Every 20,000 mi	Battery (inspect) · CV Joint Boot (inspect) · Cabin Air Filter (replace) · Door Hinge (lubricate) · Drive Axle Assembly (inspect) · Engine Coolant System (inspect fluid level)
Every 40,000 mi	Brake Rotor (inspect) · Spark Plugs (replace) · Transmission Fluid & Filter (replace)
Every 60,000 mi	Engine Air Filter Element (replace) · Engine Air Filter Housing (clean)
Every 80,000 mi	Accessory Drive Belt (inspect)